Configuring A Qos Profile; Interface Types - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - QUALITY OF SERVICE CONFIGURATION GUIDE 2010-09-22 Configuration Manual

JunosE 11.3.x Quality of Service Configuration Guide
Related
Documentation

Configuring a QoS Profile

126
Table 14: Interface Types and Supported Commands (continued)
Interface Type Queue
fr-vc
ip
ip-tunnel
ipv6
l2tp-session
l2tp-tunnel
lsp
serial
server-port
svlan
vlan
Supported Interface Types for QoS Profiles on page 125
Configuring a QoS Profile on page 126
Configuring Shadow Nodes on page 144
Before you configure a QoS profile:
Configure the traffic classes.
See "Configuring Traffic Classes That Define Service Levels" on page 14.
Configure the queuing hierarchy.
See "Configuring Queue Profiles to Manage Buffers and Thresholds" on page 22.
Configure the scheduler hierarchy and shaping with scheduler profiles.
See "Configuring a Scheduler Hierarchy" on page 47.
To configure a QoS profile:
Create a QoS profile and enter QoS Profile Configuration mode.
1.
host1(config)#qos-profile qosp-vc-queuing
Node Group
–
–
–
–
–
–
–
–
–
Copyright © 2010, Juniper Networks, Inc.
Shadow
Node