Table of Contents
Advertisement
Table 43: CLI AAA Access Message RADIUS Attributes Supported (continued)
Attribute
Number
Attribute Name
[26-21]
Alt-CLI-Virtual-Router-Name
[26-25]
Redirect-Vrouter-Name
CLI Commands Used to Modify RADIUS Attributes
This section discusses the RADIUS Internet Engineering Task Force (IETF) attributes
and the Juniper Networks vendor-specific attributes that you can configure using CLI
commands.
For many attributes, you can configure the router to include the attribute in RADIUS
messages. For more information, see "Including or Excluding Attributes in RADIUS
Messages" on page 238.
You can also configure the router to ignore many attributes that it receives in
Access-Accept messages. For more information, see "Ignoring Attributes When
Receiving Access-Accept Messages" on page 239.
For a complete list of RADIUS attributes supported by JUNOSe software, see "RADIUS
IETF Attributes" on page 259.
RADIUS IETF Attributes
This section describes the RADIUS IETF attributes that you can configure using CLI
commands. The attributes are listed numerically each attribute is followed by a list
of the commands that you can use to manage the attribute and descriptions of each
command.
[4] NAS-IP-Address
Use the following commands to configure, manage, and display information for the
NAS-IP-Address RADIUS attribute.
radius override nas-ip-addr tunnel-client-endpoint
Access-Request
–
–
radius override nas-ip-addr tunnel-client-endpoint
radius override nas-info
Use to configure the RADIUS client (LNS) to use the tunnel-client-endpoint (LAC)
IP address for the NAS-IP-Address attribute.
See radius override nas-ip-addr tunnel-client-endpoint
Example
host1(config)#radius override nas-ip-addr tunnel-client-endpoint
Chapter 3: Configuring RADIUS Attributes
Access-Accept
Access-Challenge
–
–
CLI Commands Used to Modify RADIUS Attributes
Access-Reject
–
–
191
Advertisement
Table of Contents
Troubleshooting
