Traceroute Ipv6 - NETGEAR GSM7212P User Manual

InitTTL - Enter the initial TTL to be used. The initial value is default value. The InitTTL
•
you enter is not retained across a power cycle.
MaxFail - Enter the maximum Failures allowed in the session. The initial value is
•
default value. The MaxFail you enter is not retained across a power cycle.
Interval(secs) - Enter the Time between probes in seconds. The initial value is default
•
value. The Interval you enter is not retained across a power cycle.
Port - Enter the UDP Dest port in probe packets. The initial value is default value. The
•
port you enter is not retained across a power cycle.
Size - Enter the Size of probe packets. The initial value is default value. The Size you
•
enter is not retained across a power cycle.
Click CANCEL to cancel the operation on the screen and reset the data on the screen to the
3.
latest value of the switch.
Click APPLY to initiate the traceroute. The results display in the TraceRoute area.
4.

Traceroute IPv6

Use this screen to tell the switch to send a TraceRoute request to a specified IP address or
Hostname. You can use this to discover the paths packets take to a remote destination. Once
you click the APPLY button, the switch will send traceroute and the results will be displayed
below the configurable data.
If a reply to the traceroute is received, you will see:
1 a:b:c:d:e:f:g 9869 usec 9775 usec 10584 usec
•
2 0:0:0:0:0:0:0:0 0 usec * 0 usec * 0 usec *
•
Hop Count = w Last TTL = z Test attempt = x Test Success = y.
•
To display the Traceroute IPv6 page, click Maintenance
IPv6.
Use IPv6 Address/Hostname to enter the IPv6 address or Hostname of the station you
1.
want the switch to discover path. The initial value is blank. The IPv6 Address or
Hostname you enter is not retained across a power cycle.
Use Port to enter the UDP Dest port in probe packets. The initial value is default value. The
2.
port you enter is not retained across a power cycle.
Web Management User Guide
352
 
Troubleshooting Traceroute