3Com 8807 Command Reference Manual page 582

580 C 31: IGMP S C C
HAPTER NOOPING ONFIGURATION OMMANDS
Parameter
port-number: Port number of the port to be configured as a static routing port.
Provide this argument in the format of interface-type interface-number, where the
interface-type argument can only be Ethernet port type.
vlan-id: ID of the VLAN where the port belongs to.
Description
Use the multicast static-router-port command to configure a port in a VLAN as
a static routing port, through which IGMP packets can be transparently
transmitted, so as to meet the requirements of specific networks.
Use the undo multicast static-router-port command to remove static routing
port configuration.
By default, no static routing port is configured.
Example
# Configure GigabitEthernet 5/1/1 port to be a static routing port (assuming that
GigabitEthernet 5/1/1 port belongs to VLAN 10).
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] vlan 10
[3Com-vlan10] multicast static-router-port GigabitEthernet 5/1/1
# Cancel the static routing port GigabitEthernet 5/1/1 port in VLAN10.
[3Com-vlan10] undo multicast static-router-port GigabitEthernet 5/1/1
# Configure Ethernet 5/1/1 port in VLAN 11 to be a static routing port.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800]_interface Ethernet 5/1/1
[3Com-Ethernet5/1/1 multicast static-router-port vlan 11
# Cancel the Ethernet 5/1/1static routing port in VLAN 11
[3Com-Ethernet5/1/1] undo multicast static-router-port vlan 11