3Com 8807 Command Reference Manual page 786

784 C 42: VPLS C C
HAPTER ONFIGURATION OMMANDS
Description
Use the peer command to create a VPLS peer PE contained in an instance. When
you create a VPLS peer PE, you must specify an IP address and peer type for the
peer PE.
Use the undo peer command to remove the specified VPLS peer PE. Note that, for
the undo peer command, if there are multiple peers for the same PE in an
instance, you must specify the corresponding VC-ID when you remove a peer; if
there is only one peer, you do not need to specify a VC-ID.
By default, the peer type is NPE. When you specify UPE as the peer type, it
indicates the peer is a user convergence node UPE in hierarchical VPLS
architecture. You can also specify an ID for a VC to the peer, and the ID must be
consistent with that of the remote. Multipoint-to-multipoint connections are
needed among specified multiple remote peer NPEs, but not needed between
UPEs and NPEs.
By default, VC-ID is VSI-ID.
Related command: vsi, vsi-id.
Example
# In VPLS-LDP view, create a user convergence node UPE whose IP address is
4.4.4.4 in hierarchical architecture and set the VC ID for the UPE to 200.
<SW8800> system-view view
[SW8800] vsi 3Com static
[3Com-vsi-3Com] pwsignal ldp
[3Com-vsi-3Com-ldp] vsi-id 1000
[3Com-vsi-3Com-ldp] peer 4.4.4.4 vc-id 200 upe
# For H-VPLS networking, specify two PEs, 4.4.4.4 and 5.5.5.5, as peer PEs (up to
two) that serve as primary/backup links so that when the primary link is
unavailable, the backup link is switched on.
<SW8800> system-view
[SW8800] vsi 3com static
[3Com-vsi-3com] pwsignal ldp
[3Com-vsi-3com-ldp] vsi-id 200
[3Com-vsi-3com-ldp] peer 4.4.4.4 dual-npe
[3Com-vsi-3com-ldp] peer 5.5.5.5 dual-npe
rule permit mpls Syntax
l2label-range
rule [ rule-id ] permit mpls l2label-range [ range-id ] ingress any egress any
View
Link ACL view
Parameter
rule-id: ACL rule ID.
range-id: Label range.