Integrated IS-IS Configuration Commands
475
View
IS-IS view
Parameter
acl-number: ACL number. It is in the range of 2000 to 3999, which means basic
ACLs and advanced ACLs can be used.
Description
Use the import-route isis level-2 into level-1 command to enable routing
information in a Level-2 area to be imported to a Level-1 area.
Use the undo import-route isis level-2 into level-1 command to remove the
function.
During routing leak configuration from Level-2 to Level-1, only the routes that are
permitted by ACL can be imported to Level-1 area if an ACL has been specified.
By default, routing information in a Level-2 area is not imported to a Level-1 area.
Related command: import-route.
Example
# Import routing information of a router from a Level-2 area to a Level-1 area
through the ACL.
[SW8800] isis
[3Com-isis] import-route isis level2 into level1 acl 2100
isis
Syntax
isis [ tag ]
undo isis [ tag ]
View
System view
Parameter
tag: The name given to the ISIS process. The name length should be no longer
than 128 characters, and it can be 0, which means null.
Description
Use the isis command to start the corresponding IS-IS routing process and enter
the ISIS view.
Use the undo isis command to delete the specified IS-IS routing process.
By default, IS-IS routing process is not started
For the normal operation of the IS-IS protocol, the isis command must be used to
enable the IS-IS process. Then the network-entity command is used to set a
Network Entity Title (NET) for the router. And, at last, the isis enable command is