Debugging Bgp Mp-Update; Compare-Different-As-Med - 3Com 8807 Command Reference Manual

656 C 38: MBGP M E C C
HAPTER ULTICAST XTENSION ONFIGURATION OMMANDS
Use the undo aggregate command to disable this function.
By default, no route is aggregated.
Use the aggregate command without parameters to create one local aggregated
route and set atomic aggregation attributes.
Example
# Create an aggregation entry in the MBGP routing table, with aggregated route
address as 192.213.0.0.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] bgp 100
[3Com-bgp] ipv4-family multicast
[3Com-bgp-af-mul] aggregate 192.213.0.0 255.255.0.0
compare-different-as-me Syntax
d

compare-different-as-med

undo compare-different-as-med
View
IPv4 multicast sub-address family view
Parameter
None
Description
Use the compare-different-as-med command to enable to compare the route
MED values of neighbors from different ASs.
Use the undo compare-different-as-med command to disable this function.
By default, the comparison function is disabled.
If there are multiple routes available to the same destination address, you can
select the route with the smallest MED value.
This command is not recommended unless you make sure that different ASs use
the same IGP and route selection modes.
Example
# Enable to compare the route MED values of neighbors from different ASs.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] bgp 100
[3Com-bgp] ipv4-family multicast
[3Com-bgp-af-mul] compare-different-as-med
debugging bgp Syntax
mp-update
debugging bgp mp-update [ receive | send ] [ verbose ]