Peer - 3Com 8807 Command Reference Manual

644 C 37: MSDP C C
HAPTER ONFIGURATION OMMANDS
undo originating-rp
View
MSDP view
Parameter
interface-type: Interface type.
interface-number: Interface number.
Description
Use the originating-rp command to allow a MSDP to use the IP address of
specified interface as the RP address when the SA message originated.
Use the undo originating-rp command to remove the configuration.
By default, the RP address in the SA message is the RP address configured by PIM.
Configure logical RP by using this command.
Example
# Configure IP address of the interface Vlan-interface10 as the RP address in the
SA message originated.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] msdp
[3Com-msdp] originating-rp Vlan-interface 10

peer

Syntax
peer peer-address connect-interface interface-type interface-number
undo peer peer-address
View
MSDP view
Parameter
peer-address: Address of MSDP peer.
connect-interface interface-type interface-number: Interface type and number
whose primary address is used by the local router as the source IP address to
establish TCP connection with remote MSDP peers.
Description
Use the peer command to configure an MSDP peer.
Use the undo peer command to remove the MSDP peer configured.
If the local router is also in BGP peer relation with a MSDP peer, the MSDP peer
and the BGP peer should use the same IP address.
Related command: static-rpf-peer.