Mpls Ldp Label-Accept; Mpls Ldp Loop-Detect - 3Com 8807 Command Reference Manual

LDP Configuration Commands 699
Example
# Set the maximum hop count of loop detection to 22.
<SW8800> system-view
[SW8800] mpls ldp hops-count 22
# Set the maximum hop count of loop detection to its default value 32.
[SW8800] undo mpls ldp hops-count

mpls ldp loop-detect

Syntax
mpls ldp loop-detect
undo mpls ldp loop-detect
View
System view
Parameter
None
Description
Use the mpls ldp loop-detect command to enable loop detection.
Use the undo mpls ldp loop-detect command to disable loop detection.
By default, loop detection is not enabled in the system.
If you need to enable loop detection, configure this command before LDP is
enabled on any interface.
Related command: mpls ldp hops-count and mpls ldp path-vectors.
Example
# Enable loop detection.
<SW8800> system-view
[SW8800] mpls ldp loop-detect
# Disable loop detection.
[SW8800] undo mpls ldp loop-detect

mpls ldp label-accept

Syntax
mpls ldp label-accept ip-prefix-name
undo mpls ldp label-accept ip-prefix-name
View
System view
Parameter
label-accept: Specifies an ingress label filtering policy.