1042
C
63: P
P
HAPTER
ORT
display egress counter
S
C
ACKET
TATISTICS
OMMANDS
(DP) can also be monitored. When monitoring a card, the counters can monitor all
TCs and all DPs.
After you user the set egress counter command to set the monitoring mode of a
card, the counters will be automatically reset.
By default, a card does not implement egress packet statistics.
Related command: display egress.
Note that:
You cannot configure ports as the objects to be monitored by the egress packet
■
statistics counters on GV48D, GT24D, GP24D, XP4B and XP4CA cards.
After successful configuration, it is necessary to reset the counters to start
■
counting again.
Example
# Set the egress packet statistics mode of Counter 0 on slot 4 so that it monitors
port GigabitEthernet4/1/1.
[SW8800] set egress counter0 slot 4 interface GigabitEthernet4/1/1
Syntax
display egress { counter0 | counter1 } slot slot-num [ clear ]
View
Any view
Parameter
counter0: Counter 0, used for packet statistics monitoring.
counter1: Counter 1, used for packet statistics monitoring.
slot-num: Card slot number.
clear: Clears the counting data after a counter is read.
Description
Use the display egress command to display egress packet statistics information
and the monitoring objects of a counter. To clear the counter data, include the
parameter clear in the command.
Related command: set egress counter.
Example
# Query the egress packet statistics information of slot 4, and then clear the
counter.
[SW8800] display egress counter0 slot 4 clear
Slot 4 egress counter0 mode:
Interface: all
VLAN: all
Traffic Class: all