Secondary Accounting - 3Com 8807 Command Reference Manual

362 C 21: AAA RADIUS/HWTACACS P C C
HAPTER AND ROTOCOL ONFIGURATION OMMANDS
Parameter
retry-times: The maximum number of stop-accounting request attempts. It is in
the range 1 to 300 and defaults to 100.
Description
Use the retry stop-accounting command to enable stop-accounting packet
retransmission and configure the maximum number of stop-accounting request
attempts.
Use the undo retry stop-accounting command to restore the default setting.
By default, stop-accounting packet retransmission is enabled and up to 100
packets are allowed to be transmitted for each request.
Related command: reset stop-accounting-buffer, hwtacacs scheme, and
display stop-accounting-buffer.
Example
# Enable stop-accounting packet retransmission and allow up to 50 packets to be
transmitted for each request.
[SW8800] retry stop-accounting 50

secondary accounting

Syntax
secondary accounting ip-address [ port-number ]
undo secondary accounting
View
HWTACACS view
Parameter
ip-address: IP address of the server, a valid unicast address in dotted decimal
format.
port-number: Port number of the server, which is in the range 1 to 65535 and
defaults to 49.
Description
Use the secondary accounting command to configure a secondary TACACS
accounting server.
Use the undo secondary accounting command to delete the configured
secondary TACACS accounting server.
By default, IP address of TACACS accounting server is all zeros.
You are not allowed to assign the same IP address to both primary and secondary
accounting servers.
If you repeatedly use this command, the latest configuration overwrites the
previous one.