Display Poe-Power Dc-Output State - 3Com 8807 Command Reference Manual

890 C 51: P E PSU S
HAPTER O
display poe-power
dc-output state
C
UPERVISION OMMANDS
Parameter
None
Description
Use the display poe-power alarm command to display detailed alarm
information about the PoE PSUs.
Example
# Display detailed alarm information about the PoE PSUs.
<SW8800> display poe-power alarm
PSU alarm detail, PSU number : 2
PSU 1 alarm : NORMAL
PSU 2 alarm : NOTLINK
/Rectifier not in present
Table 121 Description on the fields of the display poe-power alarm command
Field Description
NORMAL Normal
NOTLINK The PSU is disconnected. That is, the controller was able to communicate with
the PSU; but it cannot now. Power-cycling the unit or re-inserting a new PSU
can resolve this problem.
INERROR The PSU input is in trouble. Restoring the AC input can resolve this problem.
OUTERROR The PSU output is in trouble, the PSU cannot output normal DC voltage.
HIGHVOL The PSU is over-voltage. The PSU is shut down because the output voltage is
too high.
HIGHTEP It is overheated in the PSU.
FANERROR The PSU fan is in trouble.
CLOSE The PSU is shut down remotely.
CURLIMIT The PSU is current limited.
Syntax

display poe-power dc-output state

View
Any view
Parameter
None
Description
Use the display poe-power dc-output state command to display the current
DC output state of the PoE PSUs.
Example
# Display the current DC output state.
<SW8800> display poe-power dc-output state
DC Output State : Normal
Controller/Rectifier communication Fail