3Com 8807 Command Reference Manual page 1020

Hide thumbs Also See for 8807:

Table of Contents

By default, the information switch state of each channel is shown in Table 148:

Table 148 Default information switch state of each channel

Log information

If you only specify the level for one/two of the three types of information, the

level(s) of the unspecified two/one return(s) to the default. For example, if you only

define the level of the log information, then the levels of the trap and debugging

information return to the defaults.

channel-number: Channel number to be set.

channel-name: Channel name to be set. The name can be channel7, channel8,

channel9, console, logbuffer, loghost, monitor, snmpagent, trapbuffer,

state: Sets the state of the information.

state: Specifies the state as on or off.

Use the info-center source command to add/delete a record to the information

Use the undo info-center source command to cancel the contents of the

information channel.

Use this command to configure the information of log/trap/debugging type. For

example, for the filter of IP module log output, you can configure to output the

logs at a level higher than warnings to the log host and output those higher than

informational to the log buffer. You can also configure to output the trap

information on the IP module to a specified trap host, and so on.

The channels for filtering in all the directions are specified by this configuration

command. All the information will be sent to the corresponding directions

through the specified channels. You can configure the channels in the output

direction, channel filter information, filtering and redirecting of all kinds of

information.

Trap information

Debug information

Show Quick Links

Table of Contents