Slave Update Configuration; Xbar - 3Com 8807 Command Reference Manual

804 C 44: HA C C _HA_C
HAPTER ONFIGURATION OMMANDS ONFIGURATION
using a command if he expects the slave fabric to operate in place of the master
fabric. After the switchover, the slave fabric will control the system and the original
master fabric will be forced to reset.
Example
# Enable master-slave switchover manually.
<SW8800> slave switchover
Caution!!! Confirm switch slave to master[Y/N]?y
Starting.....
RAM Line....OK
slave update Syntax
configuration

slave update configuration

View
User view
Parameter
None
Description
Use the slave update configuration command to manually synchronize the
configuration file between the master and slave fabrics.
Related command: slave auto-update config.
Example
# Synchronize the configuration file between the master and slave fabrics.
<SW8800> slave update configuration

xbar

Syntax
xbar [ load-balance | load-single ]
View
System view
Parameter
load-balance: Sets Xbar load balance mode.
load-single: Sets Xbar load single mode.
Description
Use the xbar command to configure the load mode of the master/slave fabric.
By default, the master and slave fabrics are both in load single mode.
c
CAUTION: When a single fabric is in position, the load-balance mode is not
effective and the fabric changes to the load-single mode automatically.