Ip Address - 3Com 8807 Command Reference Manual

Table 11 Description on the fields of the display ip interface command
Field
ICMP packet input number
Echo reply:
Unreachable:
Source quench:
Routing redirect:
Echo request:
Router advert:
Router solicit:
Time exceed:
IP header bad:
Timestamp request:
Timestamp reply:
Information request:
Information reply:
Netmask request:
Netmask reply:
Unknown type:
DHCP packet deal mode

ip address

Syntax
ip address ip-address { mask | mask-length } [ sub ]
undo ip address [ ip-address { mask | mask-length } [ sub ] ]
View
VLAN interface view, loopback interface view, or console view
Parameter
ip-address: IP address of VLAN interface in dotted decimal format.
mask: Corresponding subnet mask in dotted decimal format.
mask-length: Mask length. That is, the number of bits with a value of 1.
sub: Specifies the IP address to be configured to be the secondary IP address of
the VLAN interface/loopback interface.
Description
Use the ip address command to assign an IP address and the corresponding
subnet mask to the VLAN interface/loopback interface/console interface.
Use the undo ip address command to remove the IP address and the
corresponding subnet mask assigned to the VLAN interface/loopback
interface/console interface.
IP Address Configuration Commands
Description
Total received ICMP packets, including:
Echo reply packets, unreachable packets,
source quench packets, routing redirect
packets, echo request packets, route
advertisement packets, route solicitation
packets, packets that exceed the time, packets
with bad IP headers, timestamp request
packets, timestamp reply packets, information
request packets, information reply packets,
netmask request packets, netmask reply
packets and unknown packets.
DHCP packet processing mode
101