Display Arp Max-Entry - 3Com 8807 Command Reference Manual

c

display arp max-entry

Use the undo arp enable size command to restore the default maximum number
of ARP entries supported by the whole switch.
By default, the whole switch supports up to 4K ARP entries, each card supports up
to 4K ARP entries, and each card supports up to 1K aggregation ARP entries.
Example
# Configure the maximum number of ARP entries of the whole switch to 64K.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] arp enable size 64
The configuration won't be enabled until the system is rebooted.
CAUTION:
You must restart the system for each of the three configurations to take effect.
■
Do not remove a card or change the place of a card from one slot to another
■
before restarting the system. Otherwise, the configuration may fail to take
effect.
After the configurations, do not perform active/standby switchover before
■
restarting the system. Otherwise, the configurations will not take effect even if
you restart the system.
Syntax
display arp max-entry
View
Any view
Parameter
None
Description
Use the display arp max-entry command to display the current maximum
numbers of ARP entries and the intending counterparts that will take effect after
the switch restarts next time.
Example
# Display the current maximum numbers of ARP entries and the intending
counterparts that will take effect after the switch restarts next time.
<SW8800> display arp max-entry
The current max arp entry config information:
max arp entry config(Main module): 65536
max link aggregation arp entry config: 0
max arp entry config of slot 0: 8192
...............
max arp entry config of slot 13: 8192
The next max arp entry config information:
max arp entry config(Main module): 65536
max link aggregation arp entry config: 8192
max arp entry config of slot 0: 8192
ARP Table Size Configuration Commands 821