Test-Enable; Test-Failtimes - 3Com 8807 Command Reference Manual

By default, no source IP address is configured. The system uses the IP address of
the source interface as the source IP address.
Example
# Set the source IP address of this test to 192.168.60.60.
<SW8800>system-view
System View: return to User View with Ctrl+Z.
[SW8800] nqa-agent enable
[SW8800] nqa administrator icmp
[3Com-administrator-icmp] source-ip 192.168.60.60

test-enable

Syntax
test-enable
undo test-enable
View
NQA test group view
Parameter
None
Description
Use the test-enable command to execute the NQA test.
Use the undo test-enable command to compulsively stop the current NQA test.
n
The test result can not be automatically displayed after the NQA test is
■
executed. You need to use the display nqa command to display the test result.
When the system is testing, parameters in the test group can not be changed
■
except the brief description of the operation and the condition of sending Trap
information to the network management system.
Example
# Execute the NQA test.
<SW8800>system-view
System View: return to User View with Ctrl+Z.
[SW8800] nqa-agent enable
[SW8800] nqa administrator icmp
[3Com-administrator-icmp] test-enable

test-failtimes

Syntax
test-failtimes times
undo test-failtimes
View
NQA test group view
NQA Configuration Commands 1083