Filter-Policy Export - 3Com 8807 Command Reference Manual

MBGP Multicast Extension Configuration Commands 663
View
Any view
Parameter
as-regular-expression: AS regular expression matched.
Description
Use the display bgp multicast routing-table regular-expression command to
view the routing information matching the specified AS regular expression.
Example
# Display routing information matching AS regular expression ^600$.
<SW8800> display bgp multicast routing-table regular-expression ^600
$

filter-policy export

Syntax
filter-policy { acl-number | ip-prefix ip-prefix-name } export [ protocol ]
undo filter-policy { acl-number | ip-prefix ip-prefix-name } export [ protocol ]
View
IPv4 multicast sub-address family view
Parameter
acl-number: Number of ACL used in matching the destination address domain of
routing information, in the range of 2000 to 3999.
ip-prefix-name: Name of the IP prefix used in matching the destination address
domain of routing information, in the range of 1 to 19.
Protocol: Protocol specifing which kind of routing information shall be filtered out,
with options currently available include direct, ospf, ospf-ase, ospf-nssa, rip,
is-is and static.
Description
Use the filter-policy export command to set to filter the advertised routes. Only
those pass through the filter can be advertised by BGP.
Use the undo filter-policy export command to cancel route filtering.
By default, filtering the advertised routes is not enabled.
The command affects route advertising by BGP. If you specify the protocol
parameter, the router only filters the routes with the specified protocol imported,
without influence on the routes importing other protocols. Otherwise, the router
filters the routes importing any protocols.
Example
# Filter all BGP-advertised routes using ACL 2000.
<SW8800> system-view
System View: return to User View with Ctrl+Z.