Filter-Policy Export - 3Com 8807 Command Reference Manual

filter-policy export

Description
Use the display ospf vlink command to view the information about OSPF virtual
links.
Example
# View OSPF virtual links information.
<SW8800> display ospf vlink
OSPF Process 1 with Router ID 1.1.1.1
Virtual Links
Virtual-link Neighbor-id
Cost: 0 State: Full
Transit Area: 0.0.0.2
Timers: Hello 10, Dead 40, Poll 0, Retransmit 5, Transmit Delay 1
Table 68 Description of the fields of the display ospf vlink command
Field
Virtual-link Neighbor-id Router ID of virtual-link neighbor router
State State
Interface IP address the interface on the virtual link
Cost Route cost of the interface
Type Type: virtual link
ID of transit area that the virtual link passes, and it cannot be
Transit Area
backbone area, Stub area and NSSA area
OSPF timers, defining as follows:
Hello
Timers Dead
Poll
Retransmit
Transmit Delay Delay time of transmitting LSA on the interface
Syntax
filter-policy { acl-number | ip-prefix ip-prefix-name } export [ routing-protocol ]
undo filter-policy { acl-number | ip-prefix ip-prefix-name} export [
routing-protocol ]
View
OSPF view
Parameter
acl-number: Number of a basic or advanced access control list.
ip-prefix-name: Name of the address prefix list used for filtering the destination
addresses in routing information.
routing-protocol: Protocol advertising the routing information, including direct,
isis, bgp, rip and static at present.
OSPF Configuration Commands
-> 2.2.2.2, State: Full
Type: Virtual
Description
Interval of Hello packet
Interval of dead neighbors
Interval of poll
Interval for retransmitting LSA on the interface
437