Debugging Bgp; Default Local-Preference - 3Com 8807 Command Reference Manual

LDP Configuration Commands 709

debugging bgp

Syntax
debugging bgp { all | event | normal | { keepalive | mp-update | open |
packet | route-refresh | update } [ receive | send ] [ verbose ] }
undo debugging bgp { all | event | normal | keepalive | mp-update | open |
packet | route-refresh | update }
View
User view
Parameter
all: Enables all types of BGP debugging.
event: Enables BGP event debugging.
normal: Enables BGP common function debugging.
keepalive: Enables BGP Keepalive packet debugging.
mp-update: Enables multi-protocol BGP Update packet debugging.
open: Enables BGP Open packet debugging.
packet: Enables BGP packet debugging.
route-refresh: Enables BGP Route-Refresh packet debugging.
update: Enables BGP Update packet debugging.
receive: Displays receive information.
send: Displays send information.
verbose: Displays detailed information.
Description
Use the debugging bgp command to enable BGP debugging.
Use the undo debugging bgp command to disable BGP debugging.
Caution should be taken in deciding to enable BGP debugging, since debugging
affects system performance. Remember to disable the debugging when it is
completed.
Example
# Enable the debugging on the detailed information about BGP Keepalive packets.
<SW8800> debugging bgp keepalive verbose

default local-preference

Syntax
default local-preference value
undo default local-preference