3Com 8807 Command Reference Manual page 1032

1030 C 61: S M C
HAPTER YSTEM AINTENANCE OMMANDS
View
Any view
Parameter
interface-type: Interface type supported by switch, including Ethernet and
GigabitEthernet.
interface-number: Interface number.
Description
Use the display fiber-module command to display the information of the optical
modules connected with all the optical interfaces in position on the current shelf,
including module information, optical module type, connector type, vendor name,
manufacturer part number, single mode or multi-mode, wave length, and
transmission distance.
Use the display fiber-module [ interface-type interface-number | interface-name
] command to display optical module information of the specified port.
Example
# Display the optical module information of all optical interfaces in position on the
current shelf.
<SW8800> display fiber-module
Pos3/1/1:
Card info: 10G-XFP
Fiber connect: LC
VendorName: Intel Corp
PartNumber: TXN181072013X07
Mode: SingleMode
WaveLength: 1310nm
Length for 9um: 10km
Pos4/1/1:
Card info: 100BASE-SFP
Fiber connect: LC
VendorName: AGILENT
PartNumber: HFBR-5760LP
Mode: MultiMode
WaveLength: Unknown
Length for 50/125um: 0m
Length for 62.5/125um: 2000m
Warning: This Port Use Wrong Optical Module !
Pos4/1/2:
Card info: 1000BASE-SFP
Fiber connect: LC
VendorName: Hitachi Cable
PartNumber: HTR6511R
Mode: SingleMode
WaveLength: 1310nm
Length for 9um: 10km
Warning: This Port Use Wrong Optical Module !