Info-Center Trapbuffer - 3Com 8807 Command Reference Manual

1020 C 60: I C
HAPTER NFORMATION ENTER
Description
Use the info-center timestamp command to configure the timestamp output
format in debugging/trap information.
Use the undo info-center timestamp command to disable the output of
timestamp field.
By default, date stamp is used.
Example
# Configure the debugging information timestamp format as boot.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] info-center timestamp debugging boot

info-center trapbuffer

Syntax
info-center trapbuffer [ size buffersize | channel { channel-number |
channel-name } ]*
undo info-center trapbuffer [ channel | size ]
View
System view
Parameter
size: Configures the size of the trap buffer.
buffersize: Size of trap buffer (numbers of messages).
channel: Configures the channel to output information to trap buffer.
channel-number: Channel number, ranging from 0 to 9, that is, the system has ten
channels.
channel-name: Channel name which can be the channel7, channel8, channel9,
console, logbuffer, loghost, monitor, snmpagent, trapbuffer, logfile
Description
Use the info-center trapbuffer command to output information to the trap
buffer.
Use the undo info-center trapbuffer command to cancel output information to
trap buffer.
By default, output information is transmitted to trap buffer and size of trap buffer
is 256, that is, the trap buffer can hold 256 messages.
This command takes effect only after the system logging is enabled.
The information can be output to the trap buffer by configuring the size of the
buffer.