Radius Scheme - 3Com 8807 Command Reference Manual

RADIUS Protocol Configuration Commands 341
Example
# Configure the source IP address that the switch uses to send RADIUS packets as
129.10.10.1.
<SW8800>system-view
[SW8800] radius nas-ip 129.10.10.1

radius scheme

Syntax
radius scheme radius-server-name
undo radius scheme radius-server-name
View
System view
Parameter
radius-server-name: Specifies the RADIUS scheme name with a character string
not exceeding 32 characters.
Description
Use the radius scheme command to configure a RADIUS scheme and enter its
view.
Use the undo radius scheme command to delete the specified RADIUS scheme.
By default, RADIUS scheme named as system has been created in the system. The
attributes of system are all default values.
RADIUS protocol configuration is performed on a per-RADIUS-scheme basis. Every
RADIUS scheme shall at least have the specified IP address and UDP port number
of the RADIUS authentication/authorization/accounting server and some necessary
parameters exchanged with the RADIUS client end (switch system). So it is
necessary to create the RADIUS scheme and enter its view before performing
other RADIUS protocol configurations.
A RADIUS scheme can be used by several ISP domains at the same time. You can
configure up to 16 RADIUS schemes, including the default scheme named as
system.
Although undo radius scheme can remove a specified RADIUS scheme. However,
the default one cannot be removed. Note that a scheme currently in use by the
online user cannot be removed.
Related command: key, retry realtime-accounting, radius-scheme, timer
realtime-accounting, stop-accounting-buffer enable, retry
stop-accounting, server-type, state, user-name-format, retry, display
radius, display radius statistics.
Example
# Create a RADIUS scheme named "3com" and enters its view.
[SW8800] radius scheme 3com
[3Com-radius-3com]