Mac-Table Limit - 3Com 8807 Command Reference Manual

782 C 42: VPLS C C
HAPTER ONFIGURATION OMMANDS
Description
Use the mac-address command to configure a static MAC address for a VSI. The
address you configured can be either a MAC address on a local VSI or a MAC
address on a remote peer.
Use the undo mac-address command to disable the configuration.
Note that when you configure a MAC address for a remote peer with the peer
keyword provided, if you specify the VLAN-interface, the command configures the
MAC address for a local peer.
Related command: vsi, display mac-address vsi.
Example
# Configure to bind the static MAC entries of VLAN interface 10 and the remote
peer to the local peer of VSI 3Com.
<SW8800> system-view view
[SW8800] mac-address static 0000-fc39-a9b5 vsi 3Com vlan-interface 1
0
[SW8800] mac-address static 0000-fc39-a9b4 vsi 3Com peer 2.2.2.2

mac-table limit

Syntax
mac-table limit mac-limit
View
VSI view
Parameter
mac-limit: Maximum number of the MAC addresses of a specific VSI.
Description
Use the mac-table limit command to configure the maximum number of the
MAC addresses in the VSI. This number ranges from 0 to 65,535 and defaults to
128. When the total number of the MAC addresses of the VSI exceeds this
number, the system no longer learns any new source MAC address; instead, it
directly broadcasts the packet in the VSI.
Example
# Set the maximum number of MAC addresses of the VSI 3Com to 1,024.
<SW8800> system-view view
[SW8800] vsi 3Com static
[3Com-vsi-3Com] mac-table limit 1024
mtu Syntax
mtu mtu
undo mtu
View
VSI view