Display Ip Routing-Table Ip-Prefix - 3Com 8807 Command Reference Manual

display ip routing-table
ip-prefix
View
Any view
Parameter
ip-address1, ip-address2: Destination IP address in dotted decimal notation.
ip-address1, mask1, mask2 and ip-address2 determine one address range
together. Anding ip-address1 with mask1 specifies the start of the range while
anding ip-address2 with mask2 specifies the end. This command is used to display
the routes in this address range.
mask1, mask2: IP address mask, length in dotted decimal notation or integer
form. It ranges from 0 to 32 when it is presented in integer.
verbose: With the verbose keyword, this command displays the verbose
information of both the active and inactive routes. Without the parameter, this
command only displays the summary of Active routes.
Description
Use the display ip routing-table ip-address1 ip-address2 command to view
the route information in the specified address range.
Example
# Display the routing information of destination addresses ranging from 1.1.1.0 to
2.2.2.0.
<SW8800>display ip routing-table 1.1.1.0 24 2.2.2.0 24
Routing tables:
Summary count: 3
Destination/Mask Protocol
1.1.1.0/24 DIRECT
1.1.1.1/32 DIRECT
2.2.2.0/24 DIRECT
For detailed description of the output information, see Table 48.
Syntax
display ip routing-table ip-prefix ip-prefix-name [ verbose ]
View
Any view
Parameter
ip-prefix-name: ip prefix list name.
verbose: With the parameter, this command displays the verbose information of
both the active and inactive routes that passed filtering rules. Without the
parameter, this command displays the summary of the active routes that passed
filtering rules.
Description
Use the display ip routing-table ip-prefix command to view the route
information that passed the filtering rule according the input ip prefix list name.
Display Commands of the Routing Table
Pre Cost Nexthop
0 0 1.1.1.1
0 0 127.0.0.1
0 0 2.2.2.1
387
Interface
Vlan-interface1
InLoopBack0
Vlan-interface2