Display Xbar; Slave Auto-Update Config - 3Com 8807 Command Reference Manual

802 C 44: HA C C _HA_C
HAPTER ONFIGURATION OMMANDS ONFIGURATION
Description
Use the display switchover state command to view the switchover state of
master or slave fabric.
This command is used to display the switchover state of the master or slave fabric
according to the specified slot number. If slot-id is not specified, the status of the
fabric will be displayed.
Example
# Display the switchover state of master fabric.
<SW8800> display switchover state
HA FSM State(master): Slave is absent.

display xbar

Syntax
display xbar
View
System view
Parameter
None
Description
Use the display xbar command to view the load mode of master and slave
fabrics, which includes the configured system Xbar load mode and the active
system Xbar load mode.
Note that the configured system Xbar load mode is not always the same as the
active system Xbar load mode. Only when the slave fabric is in position or is
started, can the system operate in the configured load mode.
Example
# Display the load mode of the master/slave fabric.
<SW8800> display xbar
The configured system HA Xbar Load Mode is BALANCE
The active system HA Xbar Load Mode is SINGLE
slave auto-update Syntax
config

slave auto-update config

undo slave auto-update config
View
System view
Parameter
None