Poe Mode - 3Com 8807 Command Reference Manual

PoE Configuration Commands 885
Parameter
max-power: Maximum power distributed to the card, ranging from 37 W to 806
W.
slot-num: Slot number of a card.
Description
Use the poe max-power command to set the maximum power on a card.
Use the undo poe max-power command to restore the default maximum power
on the card.
By default, the maximum power on a card is 806 W.
Example
# Set the maximum power on the card in slot 3 to 400 W.
[SW8800] poe max-power 400 slot 3
# Restore the default maximum power on the card.
[SW8800] undo poe max-power slot 3

poe mode

Syntax
poe mode { signal | spare | auto }
undo poe mode
View
Ethernet port view
Parameter
signal: The port supplies power through signal lines.
spare: The port supplies power through spare lines.
auto: The port supplies power in automatically selected mode.
Description
Use the poe mode command to configure the PoE mode on the current port.
Use the undo poe mode command to restore the default PoE mode on current
port.
By default, the port adopts signal lines to supply power.
c
CAUTION: 3Com Switch 8800 Family series routing switches currently do not
support the spare mode. If a PD only supports the spare mode, a conversion will
be needed.
Example
# Configure the PoE mode on current port to signal.
[3Com-GigabitEthernet3/1/1] poe mode signal