Pwsignal; Rule Permit Mpls L2Label-Range; Vpls-Load-Share - 3Com 8807 Command Reference Manual

VPLS Configuration Commands 785
Description
Use the rule permit mpls l2label-range command to add a rule for the Link
ACL. The MPLS label range ID corresponding to the rule is range-id. In this case,
the corresponding label range is 128K + range-id Ðó 16K ~ 128K + (range-id + 1)
Ðó 16K - 1. If no range-id is provided, by default, the label range corresponding to
the rule is 128K ~ 256K - 1.
Example
# Create a rule of the Link ACL. The label range corresponding to the rule is 128K
~ 256K - 1.
<SW8800> system-view
[SW8800]acl number 4000
[3Com-acl-link-4000] rule 0 permit mpls l2label-range

vpls-load-share

Syntax
vpls-load-share enable
vpls-load-share disable
View
System view
Parameter
None
Description
Use the vpls-load-share enable command to enable VPLS load sharing and allow
VPLS module switchover upon failure.
Use the vpls-load-share disable command to disable VPLS load sharing and
prohibit VPLS module switchover upon failure.
By default, VPLS load sharing is enabled; that is, switchover upon failure is
allowed. If the service on a VPLS module has been switched over to another
module, you cannot prohibit switchover upon failure.
Example
# Enables VPLS load sharing.
<SW8800> system-view
[SW8800] vpls-load-share enable

pwsignal

Syntax
pwsignal [ ldp ]
View
VSI view
Parameter
ldp: Configures the VSI to use LDP as the PW signaling protocol.