Vrrp Vrid Priority - 3Com 8807 Command Reference Manual

VRRP Configuration Commands 797
Description
Use the vrrp vrid preempt-mode command to configure the preemption and
delay of the virtual router.
Use the undo vrrp vrid preempt-mode command to cancel the preemption.
By default, virtual router is in preempt mode and delay-value is 0 second.
If a higher-priority switch is required to preempt the Master, you need to configure
it as preemption. You can also set a delay for the preemption. If you configure it
not to preempt, the delay will be set to 0 automatically.
Example
# Configure the switch to preempt.
[3Com-vlan-interface2] vrrp vrid 1 preempt-mode
# Set a delay.
[3Com-vlan-interface2] vrrp vrid 1 preempt-mode timer delay 5
# Configure the switch not to preempt.
[3Com-vlan-interface2] undo vrrp vrid 1 preempt-mode

vrrp vrid priority

Syntax
vrrp vrid virtual-router-ID priority priority
undo vrrp vrid virtual-router-ID priority
View
VLAN interface view
Parameter
virtual-router-ID: VRRP virtual router ID, ranging from 1 to 255.
priority: Priority value, ranging from 1 to 254; By default, the priority value is 100.
Description
Use the vrrp vrid priority command to configure the virtual router priority.
Use the undo vrrp vrid priority command to remove the virtual router priority.
The priority decides the status of a switch in the virtual router. A higher-priority
switch is more likely to be a Master. Priority 0 is reserved for some special purpose.
255 is reserved for the IP address owner. The priority of the IP address owner is
always 255 and cannot be modified.
Example
# Set the virtual router priority on VLAN-interface2.
[3Com-vlan-interface2] vrrp vrid 1 priority 120