Set-Overload; Silent-Interface - 3Com 8807 Command Reference Manual

490 C 26: I IS-IS C C
HAPTER NTEGRATED ONFIGURATION OMMANDS
This command is used when you want to reconfigure a certain neighbor.
Example
# Clear the IS-IS neighbor whose system ID is 0000.0c11.1111.
<SW8800> reset isis peer 0000.0c11.1111

set-overload

Syntax
set-overload
undo set-overload
View
IS-IS view
Parameter
None
Description
Use the set-overload command to set overload flag for the current router.
Use the undo set-overload command to cancel the overload flag.
By default, no overload flag is set.
If a router is configured with the overload flag, the routes it calculates will be
ignored by other routers in SPF calculation. (However the directly connected routes
will not be ignored.) And other routers should not send this router the packets
which should be forwarded by it.
Example
# Set overload flag on the current router.
[3Com-isis] set-overload

silent-interface

Syntax
silent-interface silent-interface-type silent-interface-number
undo silent-interface silent-interface-type silent-interface-number
View
IS-IS view
Parameter
silent-interface-type: Specifies the interface type.
silent-interface-number: Specifies the interface number.
Description
Use the silent-interface command to disable a specified interface to transmit
IS-IS packet.