Pim Bsr-Boundary - 3Com 8807 Command Reference Manual

628 C 36: PIM C C
HAPTER ONFIGURATION OMMANDS
Example
# Enter the PIM view.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] multicast routing-enable
[SW8800] pim
[3Com-pim]

pim bsr-boundary

Syntax
pim bsr-boundary
undo pim bsr-boundary
View
Interface view
Parameter
None
Description
Use the pim bsr-boundary command to configure an interface to be the PIM
domain border.
Use the undo pim bsr-boundary command to remove the border.
By default, no domain border is set.
You can use this command to set border of bootstrap messages, that is to say,
bootstrap messages cannot pass interfaces that are configured with pim
bsr-boundary command while other PIM messages can. In this way, the network
is divided into different BSR domains. Each domain uses a different bootstrap
router.
c
CAUTION: The pim bsr-boundary command cannot build a multicast boundary.
It just sets up a PIM bootstrap message boundary.
Related command: c-bsr.
Example
# Configure domain border on VLAN-interface10.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800]interface vlan-interface 10
[3Com-Vlan-interface10] pim bsr-boundary
pim dm Syntax
pim dm
undo pim dm