Example
# Display all the QoS parameter configurations of all the VLANs.
<SW8800> display qos-vlan all
Vlan 1 traffic-limit
Inbound:
Outbound:
Vlan 1 traffic-priority
Inbound:
Outbound:
Vlan 1 traffic-redirect
Inbound:
Outbound:
Vlan 1 traffic-statistic
Inbound:
Outbound:
Vlan 2 traffic-limit
Inbound:
Outbound:
Vlan 2 traffic-priority
Inbound:
Local
-precedence: 6, drop-priority: 1
Outbound:
Vlan 2 traffic-redirect
Inbound:
Outbound:
Vlan 2 traffic-statistic
Inbound:
Outbound:
---- More ----
display qos-vlan
Syntax
traffic-limit
display qos-vlan [ vlan-id ] traffic-limit
View
Any view
Parameter
vlan-id: ID of a VLAN, in the range of 1 to 4094.
There is no configuration.
There is no configuration.
There is no configuration.
There is no configuration
There is no configuration.
There is no configuration
There is no configuration.
There is no configuration.
Matches: Acl 2000 rule 1
Committed Information Rate: 8192 Kbps
Committed Burst Size: 10000 byte(s)
Excess Burst Size: 20000 byte(s)
Peak Information Rate: 0 Kbps
Exceed action: drop
There is no configuration
Matches: Acl 2000 rule 1
Priority action: remark-policed-service, untrusted, dscp: 13, cos: 6,
There is no configuration
Matches: Acl 2000 rule 1
Redirected to: next-hop 1.1.1.1
There is no configuration
There is no configuration.
There is no configuration.
running (Action-type: Eacl, Destination slot: 3)
running (Action-type: Eacl, Destination slot: 3)
running (Action-type: Eacl, Destination slot: 3)
QoS Commands
243