Rep 14.1 Scanner Assembly (4150) - Xerox WorkCentre 4150 Service Manual

REP 14.1 Scanner Assembly (4150)

Parts List on PL 14.10
Removal
NOTE: This procedure should only be performed on the 4150. For the 4250/4260 procedure,
refer to the table of contents.
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
Before performing this procedure, refer to General Disassembly Precautions,
1. Remove the DADF. Refer to REP 5.1.
2. Remove the rear cover, PL 28.10 Item
3. Disconnect CN2, CN3 and CN4 from the main PWB,
Figure 1 Harness removal
WorkCentre WorkCentre 4150/4250/4260WorkCentre 4150/4250/42604150/
WARNING
WARNING
CAUTION
GP
6.
Figure 1.
1
Disconnect CN2, CN3
and CN4
4. Remove 3 securing screws from the rear of the machine,
10.
5. Open the side cover assembly,
Item 2.
6. Remove the toner cartridge,
7. Remove paper tray 1.
8. Remove the exit tray assembly,
9. Remove the paper exit cover,
January 2016
4-181
Figure 2.
1
Remove 3 screws.
Figure 2 Screw removal
PL 7.30 Item 1, then the front door assembly,
PL 9.10 Item 2 then the xerographic module,
PL 28.10 Item 1 or the finisher, REP
PL 28.10 Item 4.
Repairs and Adjustments
PL 28.10
PL 9.10 Item 1.
12.1.
REP 14.1