Product Tank Agitation - Goldacres G6 Crop Cruiser 2 Series Operator's Manual

Ready to Spray – Operation
6
Lift-up to Close the foot operated ball valve at the bottom
of the hopper.
To Empty the Hopper via the Bottom
Drain Valve:
1 Lift up the lever to Close the foot operated
ball valve at the bottom of the hopper.
2 Remove the camlock coupling plug &
Open the Bottom Drain valve.
This will drain the Hopper tank & hoses.
Remove the camlock coupling plug & Open the Bottom
Drain valve.
140
On completion of emptying the hopper, Close the Bottom
Drain valve.
3 On completion Close the Bottom Hopper
Drain valve.
4 Refit the camlock coupling plug.
Refit the camlock coupling plug.
Lift & push the hopper up into its transport position.
To Raise the Chemical Induction Hopper
into Transport Postion
1 Check the hopper lid is closed and
latched.
2 Lift and push the hopper up until it latches
into its transport position.
3 Refit the locking pin to lock-in the hopper
lifting arms and refit the safety clip.
Refit the locking pin & safety clip.
Connect a 3" fill hose to the 'Clean Fill' inlet & Open the
'Clean Fill' ball valves.
Fill Pump Auxillary Valve
The Fill Pump Auxilliary Valve, located on the
Quick Filling Station, provides a clean water
outlet to facilitate auxilliary cleaning functions.
The facility utilises the clean fill inlet and fill
pump & requires a pressure hose for your
cleaning operations.
To Use the Fill Pump Aux Valve:
1 Connect a 3" suction hose (not supplied)
to the 3" 'Clean Fill' camlock coupling with
the other end of the hose connected to a
clean water source.
2 Open the 'Clean Fill' ball valves (both
Cruiser inlet valve & Suction hose valve) by
moving the handles down.
After adding chemical to the Product Tank, ensure both
Pump Product and Agitator push buttons are On to keep
the chemical evenly mixed in the tank ready for spraying.
GA8701177 REV 2 APRIL 2022