Goldacres G6 Crop Cruiser 2 Series Operator's Manual page 167

Press the 'Fold out Position (mV)' set touch button & a new value appears in the
display.
9 When the boom is fully open, press the Set touch button of
the 'Fold out Position (mV)' and a new set value appears in
the 'Fold out Position (mV)' display.
10 Press & hold the 'Boom Lower' push button on the Joystick to
lower the boom to the lowest position, then press the 'Boom
Lift' push button to raise the boom slightly so that there is
a minimum 40mm of boom cylinder rod showing on the
paralift cylinders, then release the switch.
40mm of cylinder rod is the lowest recommended 'Lower
Limit' position to be set allowing sufficient rod length for
boom cushioning movement in spraying applications.
Press & hold the 'Boom Lower' push button on the Joystick Controller to lower the
boom to its lowest position, then press the 'Boom Lift' to raise the boom slightly.
GA8701177 REV 2 APRIL 2022
Press the 'Lower Limit (mA)' set touch button & a new value appears in the
display.
11 Press the Set touch button of the 'Lower Limit (mA)' and a
new set value appears in the 'Lower Limit (mA)' display.
12 Press & hold the Boom Lift push button on the Joystick to
raise the boom until it reaches full height, then release the
push button.
13 Press the Set touch button of the 'Boom Height (mA)' and a
new set value appears in the 'Boom height (mA)' display.
Press the 'Boom Height (mA)' set touch button & a new value appears in the
Boom Settings – Service
Press & hold the UP side of the Dual Tilt rocker switch on the Joystick to tilt boom
wings up approximately 5 degrees above horizontal.
14 Press & hold the UP side of the Dual Tilt rocker switch on
the Joystick to tilt boom wings up approximately 5 degrees
above horizontal - high enough to clear boom rests but
low enough to avoid hitting the rear vision mirrors when
folding into position. Release the rocker switch when the
approximate desired tilt is reached.
As well as using the Dual Tilt rocker switch to tilt the boom, the left and right Tilt
push buttons can be used to individually adjust the boom tilt.
The Tilt Setting must be set while the boom is in its working position.
Do not attempt to set the tilt when the boom is in the folded position.
7
167