Goldacres G6 Crop Cruiser 2 Series Operator's Manual page 126

Ready to Spray – Operation
6
The 12 Volt Power terminals on the RHS of the Pod - Auxilliary Power Positive (A)
& Auxilliary Power Negative (B).
These power terminals can be used typically to drive a
chemical pump or battery charger.
The terminals must NOT to be used for jump starting.
30 Amp is maximum capacity.
Suction & Delivery Lines
Use good quality suction hose and fittings that will not collapse
or leak air under suction.
If pumping water from structures other than storage tanks, the
use of an appropriate sized floating filter equipped with a check
valve is recommended.
The suction line diameter should match the suction port
diameter of 3" to maximise pump performance.
All filling functions require the Cruiser to be safely parked in an
appropriate area with the engine running.
It is recommended to calculate the correct quantity of liquid required, and when
filling, allow sufficient quantity for adding and mixing chemicals.
If necessary top up the tank to to required quantity after adding chemicals is
completed.
126
(A)
(B)
Connect a 3" fill hose to the 'Clean Fill' inlet & Open the 'Clean Fill' ball valves.
To Fill the Product Tank - Clean water source
1 Connect a 3" suction hose (not supplied) to the 3" 'Clean
Fill' camlock coupling with the other end of the hose
connected to a clean water source.
2 Open the 'Clean Fill' ball valves by moving the handle
down.
3 Open the Filling Station storage cabinet to access the
G-hub External Controller.
All filling, adding chemicals and rinsing functions require the Cruiser's engine to be
running and the Park Brake applied.
Press the Screen Selector push button (A) to select the Fill screen, then press the
'Tank Increase' (B) or 'Tank Decrease' (C) push buttons to set the required fill volume.
4 Press the Screen Selector push button to select the Fill
screen.
5 Set the desired Fill Volume on the External G-Hub Controller
by pressing the 'Tank Increase' or 'Tank Decrease' push
buttons as required.
The desired fill volume can be entered on the G-Hub
Controller before leaving cabin.
This will always default to the usable tank volume set in the
G-Hub Controller.
If filling the Rinse Tank at the same time as the Product Tank, the 'Fill Rinse Tank'
push button will flash to indicate pausing until the Product Tank reaches 500 litre
level. Rinse Tank filling will then resume as indicated by a solid colour of the push
button. Individual tank filling rate is reduced when filling both tanks at the same
time.
GA8701177 REV 2 APRIL 2022
(A)
(B)
(C)