Goldacres G6 Crop Cruiser 2 Series Operator's Manual page 96

Set & Check Application Rates – Calibration
5
Press the 'Set-Up' touch button on the Raven home screen.
3 Press the 'Set-Up' touch button on the home screen, and
the 'Applicator Setup' screen appears.
4 Press the 'Rates Setup' touch button and the 'Rates Set-
up' screen appears.
The spraying system has the caability to enter up to 3 pre-set application rates.
Press the 'Rates Setup' touch button.
96
Press the 'Preset Rate Value Rate 1' touch button.
5 Press the 'Preset Value Rate 1' touch button and and a
numerical keypad appears.
6 Press the 'X' touch button to clear the existing number and
press the touch buttons to enter the Application Rate, eg,
70, then press the 'Tick' touch button.
The screen returns to the Rates Setup screen with '70'
displayed in the Preset Value Rate 1 value.
Press the appropriate touch buttons to enter the spray application rate required
for Rate 1 (eg, 70 l/ha), then press the 'Tick' touch button.
The screen returns to the Rates Setup screen with the new rates displayed. Press
the home screen touch button to return to the home screen.
7 Repeat steps 5 & 6 to enter preset rate values for Rate 2
(eg, 80 l/ha) and Rate 3 (eg, 90 l/ha).
The screen returns to the Rates Setup screen with all rates
(eg, 70, 80, & 90) displayed.
8 Press the 'Rate Bump' touch button and and a numerical
keypad appears.
6 Press the touch buttons to enter the desired 'Rate Bump'
value (l/ha), eg, 5, then press the 'Tick' touch button.
The screen returns to the Rates Setup screen with eg, '5'
shown in the Rate Bump display.
8 Press the home touch button to return to the home screen.
This completes the controller entries for the single line boom
calibration.
Rate Bump
When spraying in Manual Mode, the operator can adjust the Spray Application
Rate (using touch buttons on the Controller) by the amount (l/ha) pre-set in the
Spray Bump setting.
GA8701177 REV 2 APRIL 2022