Lubrication & Maintenance - Service - Goldacres G6 Crop Cruiser 2 Series Operator's Manual

Regularly do the routine checks on the Cruiser while
stationary.
Pre-Operation Checklist
Stationary Checks
The following should be routinely done while
the Cruiser is stationary:
• Check all tyre pressures for the
recommended pressures in the manual
• Check all wheel nut torque (350 ft lb)
• Check mudguard mountings (where
fitted)
• Inspect axles for fractures or cracks
• Check axle retaining hardware
• Check sway bar bushes & bolt tension
• Check all pump mounting bolt tensions
• Check tension of tank straps
• Check all oil levels:
• Engine
• Transmission
• Transfer case
• Differentials
• Drop legs
GA8701177 REV 2 APRIL 2022
Regularly check the engine coolant level.
• Check engine coolant level
• Check/change engine inline fuel filter
• Check engine filters for leaks
• Check oil drain plugs for leaks
• Drain water separator
• Check all electrical ground points are
clean and tight
• Check all fasteners are tight
• Check & tighten hose clamps on main
hose from pump to manifold
• Clean suction filter
• Clean pressure filters
• Check all filter bowl nuts and O-rings
• Check paralink arm mounting bolt
tension (300ft/lb)
• Check toe in of steer axle (0-5mm)
• Check boom alignment.
Lubrication & Maintenance – Service
Check & adjust all seat & steering column adjustments for
personal comfort.
Running Checks
The following should be routinely done while
the Cruiser is running:
• Check all light functions
• Check all air conditioner controls
• Check radio functions
• Check UHF radio functions
• Check all seat adjustments
• Check all steering column adjustments
• Set-up the engine monitor
• Check all warning sound alarms
function correctly
8
Check all joystick boom switch functions.
• Check boom switches operate
• Check all hoses for leaks and/or
excessive movement
• Check air bag axle ride height
• Check air bag system for air leaks
• Inspect airbag reservoir & drain any
liquid
Check airbags are functioning correctly.
175