Goldacres G6 Crop Cruiser 2 Series Operator's Manual page 133

Connect a hose for Micromatic filling to the Chemical Probe
Inlet.
B) To Add Liquid Chemical to the Hopper
Using the Micromatic Coupling
1 Connect a Micromatic hose to the 1"
Chemical Probe Inlet.
2 Connect the other end of hose to a
chemical source using the Micromatic
coupling.
3 Rotate the Chemical Pump Output
Selector to 'Hopper' position.
Rotate the Chemical Pump Output to Hopper position.
GA8701177 REV 2 APRIL 2022
Press the 'Pump Product' push button On to engage
suction of the Product Pump from the Product Tank.
4 Press the 'Pump Product' push button On
to engage suction of the Product Pump
(from Product tank).
5 Turn the 'Chemical Pump' On (rotate the air
valve to On).
Chemical will begin transfering to the
Chemical Induction Hopper.
Turn the Chemical Pump valve ON.
Operation – Ready to Spray
Rotate the Chemical Pump valve to Off position.
6 After the required amount of chemical has
been transfered to the hopper, the Enviro
coupler can be partially disconnected to
allow air to suck into and clear fluids in the
pump and hoses.
7 Close the Chemical Pump Valve.
Micromatic Hose Rinse
The Micromatic Hose Rinse function can only be used
while filling the Product & Rinse tanks with clean water and
the 'Fill Product' push button is On.
Connect the hose to the Micromatic coupling on the
Cruiser, then Open the Rinse Coupling Valve.
To rinse the Micromatic Hose & Fittings:
1 Disconnect the Micromatic hose end from
the chemical source, then connect it to the
Micromatic Rinse Coupling on the Cruiser
& Open the Rinse Coupling Valve (located
above the coupling).
2 Select either Hopper or Product Tank to
rinse the desired circuit.
3 Turn the 'Chemical Pump' On (rotate the air
valve to On).
Rinse will transfer to the Chemical
Induction Hopper or Product Tank..
Turn the Chemical Pump valve ON.
6
133