Pre-Set The G-Hub Controller - Goldacres G6 Crop Cruiser 2 Series Operator's Manual

Press the 'Off Rate Alarm' touch button. Enable the
'Alarm?'. Press the 'Next' touch button.
66 Press the 'Off Rate Alarm' touch button
and a keypad appears. Press the touch
buttons to enter the rate value, eg '20' (%),
then press the 'Tick' touch button.
The 'Setup Rates' screen returns with '20'
displayed in ''Off Rate Alarm''.
67 Press the 'Alarm?' checkbox to enable
the alarm. A 'Tick' appears when the
'Alarm' is enabled (the checkbox is blank if
disabled).
68 Press the 'Next' touch button and a
'Setup Summary' screen appears.
If the number of boom sections and/or section widths are
phyically altered at anytime, then the Application Width
and Section Width inputs need to be changed accordingly.
GA8701177 REV 2 APRIL 2022
Review the setting summary, then press the 'Next' touch
button.
69 Review the Setup Summary page to check
all is correct.
This completes the RCM initial setup
procedure. After completion of the RCM
setup, no further setup in this procedure
is necessary unless the boom and its
components are physically altered or
changed.
70 Press the 'Next' touch button and a
'System Settings' screen appears.
Now that the RCM is preset, any required
application rate changes and most system
changes are made from this screen.
Use this screen to make futher application or system
changes.
Setting Up – Preparation for Use
Engine & Drivetrain Information
Goldacres G-Hub Touch Screen illustrating three sections of touch control & data information.
Pre-Set the G-Hub
Controller
Goldacres G-Hub Controller is pre-set and
tested for spraying applications prior to
delivery.
However, it is recommended that all settings
and operation be checked and tested for
accuracy prior to spraying applications.
Goldacres G-Hub Touch Screen in the cabin with Armrest
Control Console and Joystick Controller.
Sprayer Operation Menu
It is the operator's responsibility to correctly
operate all controller and sprayer functions at
all times.
The Settings touch button in the Menu
column on the right hands side of the G-Hub
Operating screen gives access to 7 screens
for settings, diagnostics and service, namely:
1 Display
2 Machine
3 Plumbing
4 Hydraulics
5 Engine
6 Diagnostics (refer to chapter 8,
Lubrication & Maintenance for details)
7 Service (refer to chapter 8,
Lubrication & Maintenance for details).
Pre-setting the G-Hub uses the first 5 of these
screens.
4
73