Goldacres G6 Crop Cruiser 2 Series Operator's Manual page 120

Ready to Spray – Operation
6
Press the 'R' push button to engage reverse gear for
reversing the sprayer.
Reverse Gear
Press the 'R' push button to engage reverse
gear to reverse the sprayer.
Neutral
Press the 'N' push button to place the unit in
Neutral (all gears deactivated).
The gear selector must be in Neutral to start
the engine & before selection of a gear to start
driving.
Press the N push button to deactivate all gears.
120
Press the D push button to engage reverse gear for
reversing the sprayer.
Drive
Press 'D' push button to engage forward
gears. When Drive is pressed, the 1st gear
through to 6th gear is available and will be
selected by the Electronic Control Module
(ECM) when changing Up or Down.
Overdrive gears 5th & 6th can only be
engaged in Road Mode if the Enable Overdrive
is not preset. Refer to Chapter 4, Setting Up.
Enable Overdrive when selected allows the
operator to use the 5th & 6th gears while in
Spray Mode and maintain the operation of
Autosteer.
The G-Hub system will log any faults that occur. Go to
Chapter 9 'Trouble Shooting' for more information.
If Drive (D) or Reverse (R) are pressed while the Park Brake
is still On, a gear cannot be engaged by the transmission
and an audible alarm will sound.
Press the Gear Up (Arrow up) or Gear Down (Arrow down)
push button to manually change gears Up or Down.
Gear Up
The 'Arrow Gear Up' push button allows the
operator to manually upshift the transmission
one gear at a time when the transission is in
Drive. Press the 'Arrow Gear Up' push button
once for each gear change.
The Select Display shows the gear range
selected & the Monitor Display shows the gear
currently engaged.
Gear Down
The 'Arrow Gear Down' push button allows
the operator to manually downshift the
transmission one gear at a time until the 1st
gear is reached.
Press the 'Arrow Gear Down' push button
once for each gear change. The Select
Display shows the gear range selected & the
Monitor Display shows which gear currently
engaged.
The transmission cannot not shift above the gear range
selected. When Drive (D) is pressed the full range of
automatic shifting is restored.
Press the 'Mode' push button to engage the Pre-Select
Pre-Select 3rd Gear
The Pre-Select 3rd Gear push button allows
the operator to quickly select 3rd gear.
It is activated by pressing the 'Mode' push
button on the Transmission Controller'. A
light illuminates in the top right corner of the
Pre-Select 3rd Gear push button when it is
activated (selected).
The indicator light of the push button goes
dark to indicate when the gear selection is
inactive (Off).
GA8701177 REV 2 APRIL 2022