Multifunction Lever - Goldacres G6 Crop Cruiser 2 Series Operator's Manual

1 Horn
2 Windscreen Washer
3 Windscreen Wiper
4 Turning Indicators

Multifunction Lever

The Multifunction Lever is located on the left
hand side of the steering column below the
steering wheel.
This lever has seven functions:
1 Horn
2 Windscreen Washer
3 Windscreen Wiper
4 Turning Indicators
5 Headlight High/Low Beam
6 Headlight Flasher
1 Horn
The Horn button is located on the outer
end of the Multifunction Lever.
Use a left hand fingertip to press the
Horn button inwards (toward the steering
column) to sound the Horn.
Stop pressing the button to stop the horn
sounding.
2 Windscreen Washer
The Windscreen Washer control is located
next to the Horn buttom close to the end
of the Multifunction Lever.
GA8701177 REV 2 APRIL 2022
The Multifunction Lever (located on the left hand side of the steering column below the steering wheel) controls seven
functions as shown. Refer to numbered information & headings on this page for instruction.
Use the left thumb and fingers to grasp
the Windscreen Washer button and push
the button inwards (toward the steering
column) to activate water through the
windscreen washers.
To stop water flowing through the
windscreen washers, release the button.
3 Windscreen Wiper
The Windscreen Wiper rotating barrel
switch is located next to the windscreen
washer button.
Use the left thumb and fingers to rotate
the barrel switch (top forward) to the
desired setting (aligning the arrow with):
J - Intermittent wiper function
I - Constant wiper function.
Cabin – Your Sprayer at a Glance
Rotate the barrel switch in the opposite
direction (top rearward) to return the wiper
function to:
J - Intermittent wiper function or
O - Wiper function Off.
4 Turning Indicators
Pull the Multifunction Lever counter-
clockwise around the steering column to
activate the Left Turning Indicator.
Push the Multifunction Lever clockwise
around the steering column to activate
the Right Turning Indicator.
Return the Multifunction Lever to neutral
off position after turning.
6 Headlight Flasher
5 Headlight High/Low Beam
5 Headlight High/Low Beam
The headlights must first be turned On at
the Overhead Console headlight switch
(see page 37 for instructions).
In the centre position (horizontally) the
headlights will be on high beam.
Using the left hand, push the
Multifunction Lever downward to move to
low beam.
Move the Multifunction lever upwards
back to high beam as required.
6 Headlight Flasher
Use left hand to lift the Multifunction
Lever fully upwards/intermittently to flash
the headlights On/Off for a warning.
The flasher function works with or without
the overhead console light switch On.
3
33