Goldacres G6 Crop Cruiser 2 Series Operator's Manual page 86

Preparation for Use – Setting Up
4
Press the touch button to select/deselect Enable Variable Cruise Control.
iv) Enable Variable Cruise Control
The Enable Variable Cruise Control is selected to enable the
Joystick Control to be used in the variable cruise control mode.
This gives the operator variable speed between the set upper
& lower cruise speeds by moving the joystick forwards or
rearwards.
The lower speed limit is set on this screen and the upper speed
limit is set using the Joystick cruise set button.
To Select the Enable Variable Cruise Control:
Press the 'Enable Variable Cruise Control' touch button to
select or deselect the function.
The touch button displays Green when selected (enabled) &
Grey when deselected (disabled).
The Enable Variable Cruise Control cannot be used with the 2 Speed Only Control
function.
If using the Enable Variable Cruise Control function, deselect the 2 Speed Only
Control touch button and select the Enable Variable Cruise Control touch button
to enable the 2 speed control function.
86
Press the touch button to select/deselect 2 Speed Only Cruise Control.
v) 2 Speed Only Cruise
The 2 Speed Only Cruise is selected to enable the Joystick
Control to be used in non-variable cruise control mode.
2 Speed Only Cruise control gives the operator the choice of
two speeds, the upper & lower speeds by moving the Joystick
forwards or rearwards.
The lower speed limit is set on this screen and the upper speed
limit is set using the Joystick cruise set button.
To Select the 2 Speed Only Cruise Control:
Press the '2 Speed Only Cruise' touch button to select or
deselect the function.
The touch button displays Green when selected (enabled) &
Grey when deselected (disabled).
The 2 Speed Only Cruise cannot be used with the Enable Variable Cruise Control
function.
If using the 2 Speed Only Control function, deselect the Enable Variable Cruise
Control touch button and select the 2 Speed Only Cruise touch button to enable
the 2 speed control function.
Press the touch button to select/deselect Enable Overdrive.
vi) Enable Overdrive
The Enable Overdrive when selected allows the operator to
select Overdrive (5th & 6th gears) while in Spray Mode and still
maintain the operation of the Autosteer.
If Enable Overdrive is not selected, then the Autosteer function
is disengaged when using 5th and 6th gears (Road Mode).
To Enable Overdrive:
Press the 'Enable Overdrive' touch button to select or
deselect the function.
The touch button displays Green when selected (enabled) &
Grey when deselected (disabled).
GA8701177 REV 2 APRIL 2022