Goldacres G6 Crop Cruiser 2 Series Operator's Manual page 75

Press the 'Password' space & a numerical keypad appears.
To Unlock the Machine Tab Screen:
1 Press the 'Unlock to change' touch button at the bottom
RHS of the panel and a password request appears.
2 Press the password space and a numerical keypad
appears.
3 Press the numerical touch buttons to enter the password
'1978', and press the 'Enter' touch button. The screen
returns to the 'Password' with '****' displayed.
4 Press the 'OK' touch button and the screen returns to the
Machine Screen.
Press the touch buttons '1978' to enter the password, then press 'Enter'.
GA8701177 REV 2 APRIL 2022
Press the Machine tab & select the appropriate settings for your machine - items
(i), (ii), (iii) & (iv).
To Select the Appropriate Settings for your Cruiser:
i) Sprayer Model
Press the touch button applicable to your machine:
• G6 Crop Cruiser or
• G8 Super Cruiser model.
The touch button goes Green when selected or Grey when
deselected.
ii) 4WD
iii) Boom Type
Press the touch buttons applicable to your machine:
• Bi-fold (36 or 42m boom)
• Tri-fold boom (48m boom)
• 3TS
• 3TS Pro
Touch buttons go Green when selected or Grey when
deselected.
iv) Pump Type
Press the touch buttons applicable to you machine:
• Zeta 260 or
• High flow centrifugal pump.
The touch button goes Green when selected or Grey when
deselected.
Setting Up – Preparation for Use
Press the SAVE touch button to save the boom calibrations settings.
v) Boom Calibration - for the Auto-Folding Boom function
applicable to 36m, 42m & 48m booms.
The Boom Calibration values are set while operating the
boom manually.
For instructions on 'Boom Calibration' refer to chapter 7,
'Lubrication & Maintenance' under 'Test Folding the
Boom'
When Machine settings are completed, press the 'SAVE' touch
button on the left hand side of the screen to save the settings
into the G-Hub system.
If you don't press 'SAVE' touch button, the calibration settings
entered on the Machine screen will be lost.
After Save is pressed, the G-Hub Home screen will return. It
will then be necessary to press the 'Setting' touch button to
continue with pre-setting.
Set the Boom Calibration values to zero (0) to disable the Auto-Folding boom
function.
4
75