Goldacres G6 Crop Cruiser 2 Series Operator's Manual page 69

Individually press each 'Section' touch button from 1st to
16th to set the individual switches.
27 Press the Next touch button and a 'Switch
Mapping' screen appears.
28 Individually press each 'Section' (1-16)
touch button and a numerical list appears.
Select & press the switch number. eg.
'1' and the screen returns to the Switch
Mapping screen with '1' displayed.
Repeat for each section.
29 On completion press the Next touch
button and a 'Section Summary' screen
appears.
Select & press the switch number required.
GA8701177 REV 2 APRIL 2022
Review the information on the Section Summary screen.
Press the 'Next' touch button.
30 Review the information on the Section
Summary screen.
If any change is required, press the 'Back'
touch button to the screen(s) required to
make the change(s).
31 Press the 'Next' touch button and a
'Setup Pressure Sensors' screen appears.
32 Press the 'Pressure Sensor 1' touch
button and a Pressure Sensors menu
appears.
33 Select & press the '0-250psi (1-5v)'
pressure sensor setting and the screen
returns to the Setup Pressure Sensors
screen with '0-250psi (1-5v)' displayed.
Press the 'Pressure Sensor 1' touch button. Press the
'Next' touch button.
Setting Up – Preparation for Use
Select & press the '0-250psi (1-5v)' touch button pressure
sensor setting.
34 Press the 'Next' touch button and a
'Setup Pressure Alarms' screen appears.
35 Press the 'Min' touch button and a 'Set
Pressure Alarms' keypad appears.
Press the 'Min' Pressure 1 touch button. Press the 'Max'
Pressure 1 touch button. Press the 'Next' touch button.
Press the touch buttons to set minimum pressure value eg,
'100', then press the 'Tick' touch button.
36 Press the touch buttons to set the
minimum pressure value eg, '100', then
press the 'Tick' touch button.
The 'Setup Pressure Alarms' screen
returns with the value eg, '100' showing in
the 'Min' display.
37 Press the 'Max' touch button and a 'Set
Pressure Alarms' keypad appears.
Press the touch buttons to set the minimum
pressure value eg, '800', then press the
'Tick' touch button.
The 'Setup Pressure Alarms' screen
returns with the value eg, '800' showing in
the 'Max' display.
Press the touch buttons to set maximum pressure value eg,
'800', then press the 'Tick' touch button.
4
69