Goldacres G6 Crop Cruiser 2 Series Operator's Manual page 127

Press the 'Fill Product' push button, then 'Fill Pump' push button to start filling
the Product Tank.
6 With the Cruiser engine running at low idle, press the 'Fill
Product' push button to On, then
7 Press the 'Fill Pump' push button to On to start filling the
Product Tank.
The Cruiser engine RPM will automatically raise if enabled in
the G-Hub Controller settings.
The Fill speed can be reduced if required by holding the 'Fill
Product' push button for 2 seconds if more time is required.
8 The Fill Pump automatically switches Off when the target
product volume is reached.
The filling process can be stopped at any time by pressing
'Fill Pump' Off.
9 When filling is complete, close the 'Clean Fill' ball valves
(Cruiser & suction hose) and disconnect the suction hose
from the camlock coupling.
It is important to not close the 'Clean Fill' valve while the pump is running.
Running the pump with a closed suction inlet may damage the pump.
GA8701177 REV 2 APRIL 2022
Connect a 3" fill hose to the 'Dirty Fill' inlet & Open the 'Dirty Fill' ball valves.
To Fill the Product Tank - Dirty water source
1 Connect a 3" fill hose (not supplied) from a suitable
pumping system to the 'Dirty Fill' camlock coupling of the
Filling Station.
2 Follow all relevant safety & set-up pumping guidelines for
the system being used.
3 Open the 'Dirty Fill' ball valves by moving the handle down.
Before disconnecting the suction hose from the Clean Fill Inlet, it should be noted
the Drum Rinse & Hopper Rinse nozzles both require the use of suction hose for
the supply clean water when rinsing.
If hopper rinsing will be required, keep the suction hose connected to the clean
water source until completion of the rinsing functions.
Operation – Ready to Spray
Press the Screen Selector push button (A) to select the Fill screen, then press the
'Tank Increase' (B) or 'Tank Decrease' (C) push buttons to set the required fill volume.
4 Open the Filling Station storage cabinet to access the
G-hub External Controller.
5 Press the Screen Selector push button to select the Fill
screen
6 Set the desired Fill Volume on the External G-Hub Controller
by pressing the 'Tank Increase' or 'Tank Decrease' push
buttons as required.
The desired fill volume can be entered on the G-Hub
Controller before leaving cabin.
7 With the Cruiser engine running at low idle, press the 'Fill
Product' push button to On, then Press the 'Fill Pump'
push button to On to start filling the Product Tank..
Fill progress can be monitored on the External G-Hub
Controller screen.
8 When the tank is filled to the desired level, a 3" Fill Control
Valve will close (stopping flow to the tank). Stop the
pumping system.
9 Close the 'Dirty Fill' ball valves (Cruiser & supply hose) and
disconnect the supply hose from the camlock coupling.
6
(A)
(B)
(C)
127