Goldacres G6 Crop Cruiser 2 Series Operator's Manual page 137

Rotate the Chemical Pump valve to Off position.
4 Rotate the 'Chemical Pump' valve to Off
position.
5 Rotate the Chemical Probe valve to Off
position.
Rotate the Chemical Probe valve to Off position.
GA8701177 REV 2 APRIL 2022
Close the Rinse Coupling Valve, then disconnect the hose
from the Micromatic coupling on the Cruiser.
6 Close the Rinse Coupling Valve, then
disconnect the Micromatic hose from the
Micromatic Rinse Coupling on the Cruiser.
7 Disconnect the other end of the hose from
the 1" Chemical Probe Inlet & refit the
camlock cap.
Disconnect the Micromatic hose from the Chemical Probe
Inlet & refit the camlock cap.
Operation – Ready to Spray
The Hopper Rinse Nozzle located under the hopper lid.
Hopper Rinse Functions
The Chemical Induction Hopper provides
several rinsing functions:
a) Drum Rinse Nozzle
b) Hopper Rinse Nozzle
a) Wash Down Gun
After rinsing, the Chemical Induction Hopper
can be emptied by:
• Transfering contents to the Product
Tank (see previous instruction) or
• Emptying the Hopper via the Bottom
Drain valve.
The Wash Down Handgun on the outside of the hopper.
Connect a 3" fill hose to the 'Clean Fill' inlet & Open the
'Clean Fill' ball valves.
a) To Use the Drum Rinse Nozzle
Connect a 3" suction hose (not supplied)
to the 'Clean Fill' camlock coupling with
the other end connected to a clean water
source.
2 Open the 'Clean Fill' ball valves by moving
the handles down (Cruiser & Suction
hose).
3 Check the 'Hopper Rinse' valve on the top
of the hopper is Closed.
Check the 'Hopper Rinse' valve on the top of the hopper
is Closed.
6
137