Goldacres G6 Crop Cruiser 2 Series Operator's Manual page 62

Preparation for Use – Setting Up
4
Remove the screws from the antenna connectors cover.
To Install the GPS Antenna:
The GPS Antenna connectors are located
within the roof space on the left hand side of
the cabin and the antenna platform is located
on the top of the cabin roof.
To access & fit antenna connectors:
1 Remove two screws from the front & rear
of antenna connectors cover above the
cabin door.
2 Remove the cover to access the antenna
connectors.
The cover removed showing the antenna connectors.
62
3 Fit & screw the COAXIAL Cable A fitting to
the front COAXIAL A connector.
4 Feed the other end of the COAXIAL Cable
through the eave of roof to the magnet
plate on top of the cabin.
6 Fit the end connector of the COAXIAL
Cable to the Trimble Antenna.
7 Place the Trimble Antenna onto the
magnetic plate and adjust the COAXIAL
Cable to move any excess cable back into
the roof space.
8 On completion of fitting the antenna, refit
the cover & screws above the left hand
cabin door.
The Trimble antenna on the cabin roof magnetic plate.
To Fit the Trimble Autosteer Console:
1 Obtain the optional Goldacres Raven ISO
to Trimble connecting cable.
2 Fit the Raven ISO to Trimble cable
connnector to the Terminal ISO connector
located on the rail in right hand side of the
cabin.
3 Fit the Trimble Autosteer Console to the
ball mount on the rail at the right hand side
of the cabin.
4 Fit the other end of the Raven ISO to
Trimble cable connnector to the connector
on the back of the Autosteer Console
Ball mount fitted on the rail ready for the Autosteer Console.
The electrical compartment cover refitted & locked into
position.
6 On completion of the Autosteer
installation, refit the cover of the Electrical
Compartment and fold down the latches
to lock the cover into position.
7 Close & lock the right hand cabin door and
lower the armrest control console into its
working position.
GA8701177 REV 2 APRIL 2022