Quick Rinse Or Boom Rinse - Goldacres G6 Crop Cruiser 2 Series Operator's Manual

Hide thumbs Also See for G6 Crop Cruiser 2 Series:
Table of Contents

Advertisement

Screen switches of the 'Pressure Filter Clean' function.
10 The 'Filter Clean' function of the G-Hub Controller can be:
Set to 'Auto' setting so that the pressure filter flushing
automatically activates when all boom sections are
switched Off or the boom Master Switch is turned Off.
Manually switched to On to flush the pressure filter
when not actively spraying.
Refer to Chapter 3 'Cabin', 'Pressure Filter Clean Touch
Buttons' for instructions).
11 As the Product Tank gets closer to minimum tank level (300
litres), it may be necessary to switch Off the Agitator to
reduce foaming.
The operator must wear the operator safety belt at all times when seated in the
cabin or when the machine is in motion.
GA8701177 REV 2 APRIL 2022
Press the 'Boom Master On/Off' push button on the Joystick to stop spraying.
12 When the Product Tank is empty:
Press the 'Boom Master On/Off' push button Off (using
the Joystick to stop spraying
Stop the Agitator
Stop the Pump, and
Return to water source to refill (refer to 'Filling the
Sprayer' & 'Adding Chemicals to the Product Tank'.
13 On completion of spraying at:
End of the day
End of a product or
End of season,
follow the appropriate rinsing instructions to ensure all
plumbing is flushed & completely clean.
Do not run a centrifugal pump dry as damage will occur to the pump.
Operation – Ready to Spray
Connect a 3" fill hose to the 'Clean Fill' inlet & Open the 'Clean Fill' ball valves for
filling & rinsing water.
Rinsing the Sprayer After Spraying
Never leave chemical or contaminated liquid within the Cruiser's
spraying system. After spraying the spraying system must be
rinsed clean. Three modes of rinsing provided:

1 Quick Rinse or Boom Rinse

2 Basic Rinse
3 Total Rinse & Decontamination.
When rinsing is taking place, the rinsate is potentially very hazardous depending
on chemical content.
Use recommended personal protective equipment (PPE).
For specific information on rinsing & decontamination of the chemicals being
applied, it is recommended to consult the chemical manufacturer's label and/or
your chemical supplier.
6
143

Advertisement

Table of Contents
loading

Table of Contents