Goldacres G6 Crop Cruiser 2 Series Operator's Manual page 98

Set & Check Application Rates – Calibration
5
Press the 'Tier 2 Max Flow Rate' touch button.
6 Press the 'Tier 2 Max Flow Rate' touch button and and a
numerical keypad appears.
7 Calculate Max Flow Rate of the 2nd Tier nozzles fitted to
the boom, eg, AXIR11002 nozzle @ 5 Bar 1.02 l/min.
Multiply 1.02 x 72 (number of nozzles) = 73.5 l/min.
8 Press the 'X' touch button to clear the existing number and
press the touch buttons to enter the Max Flow Rate, eg,
73.5, then press the 'Tick' touch button.
The screen returns to the Tiered Boom Setup screen with
'73.5' in the Tier 2 Max Flow Rate value.
9 Press the 'Tick' touch button and the screen returns to the
System Setting screen.
This completes the controller entries for the 3TS Option boom
calibration.
Percent Tier Disable
The 'Percent Tier Disable' value is usd to minimise unnecessary tier switching
when spraying close to the switch point of a tier. Increasing the value, reduces the
sensitivity when switching tiers.
The '10% Percent Tier Disable' value means a spraying Tier will not change down
until the spray rate is 10% below the target rate.
98
c) Enter Values for 3TS Pro Option
After nozzle selection, the 3TS Pro configuration requires new
values to be entered into the controller according to the nozzles
selected, namely:
• Spray application rates
• Maximum flow rate (for each tier/nozzle fitted [3 tiers]).
To Enter New Application Rates:
Follow the steps 1 - 8 previously given under 'Enter Values for
the Single Line Boom'.
Press the 'Tier 3 Max Flow Rate' touch button.
To Enter New Maximum Flow Rates:
1 Follow the steps 1 - 8 previously given for the 3TS Option
entering the appropriate values, then
2 Press the 'Tier 3 Max Flow Rate' touch button and a
numerical keypad appears.
3 Calculate Max Flow Rate of the 3rd Tier nozzles fitted to the
boom, eg, AXIR110025 nozzle @ 5 Bar 1.28 l/min.
Multiply 1.28 x 72 (number of nozzles) = 92.2 l/min.
4 Press the 'X' touch button to clear the existing number and
press the touch buttons to enter the Max Flow Rate, eg,
'92.2', then press the 'Tick' touch button.
Press the appropriate touch buttons to enter the Max Flow Rate for Tier 3 (eg,
92.2 l/min), then press the 'Tick' touch button.
GA8701177 REV 2 APRIL 2022